FANUC 15MA 2pallet, Table 1250×1250(There is a discrepancy from manual)×2 XYZW 3000×2700×800(Ram) ×1000(Cross rail) Angle head 90deg indexing×4(AAC) Spindle speed 2500, ATC200 AAC1（90deg indexing,1,800 rpm） Work piece weight 3000kg Two machines only share chip conveyor

FANUC-16iMB XYZW 1800×2000×1300×600mm　 B : 1/1000deg index spindle : 4000rpm, ATC40 Table : 1800×2200mm, BT50, Max.load weight 15t Coolant through spindle, Touch sensor, Tool length measurement

FANUC-15MB XYZW 2100×1500×1500×600 B : 1/1000deg index 3PL , BT50, 10000rpm, ATC60 Coolant through spindle Touch sensor Tool length measurement Max. load weight 8t Table ①1500×1500　 　　 ②1500×1700 　　 ③1500×1500 Touch sensor is only attached receiver

XYZ 2200×3000×1500　 A : -20~40deg(0.0001deg) C : 360deg(0.0001deg) Table 1800×2200, BT50 8000rpm, ATC60, Touch sensor Tool length measurement Max. load weight 15t Spindle through coolant Scale feed back 800mm delving Required floor space 6750×3010

100A, System3R, ATC16 Table 1400×950(from catalog) XYZ 1000×600×450(from catalog)

ADVANCE Max. work piece size 810×700×215 Table 640×450 XYZ 400×300×220

XYZ 500×350×300 Max. work piece size 1050×800×295 Work piece loading weight 1500kg Wire electric diameter 0.1~0.3 Attached 20kg winding

FANUC-21T Swing over bed 810 Swing over carriage 520 Distance between center 1035 Turning diameter 465 Turning length 785 XZ 315×825 Spindle speed 25~2500min-1 Spindle bore 100 Travel of tail stock 760 Required floor space 3786×1975 12 inch chuck

請來電洽詢

請來電洽詢